[UPLOAD=rar]ShowFile.asp?ID=64[/UPLOAD]
附件尺寸：279.67 KB
Introduction
The USB-Blaster™ download cable interfaces a USB port on a host computer to an
Altera® FPGA mounted on a printed circuit board. The cable sends configuration data
from the PC to a standard 10-pin header connected to the FPGA. You can use the
USB-Blaster cable to iteratively download configuration data to a system during
prototyping or to program data into the system during production.
Supported Devices
You can use the USB-Blaster download cable to download configuration data to the
following Altera devices:
■ Stratix® series FPGAs
■ Cyclone® series FPGAs
■ MAX®
series CPLDs
■ Arria® GX series FPGAs
■ APEX™ series FPGAs
■ ACEX® 1K FPGAs
■ Mercury™ FPGAs
■ FLEX 10K® series FPGAs
■ Excalibur
™ FPGAs
You can perform in-system programming of the following devices:
■ Altera configuration devices including EPC2 devices.
■ Enhanced configuration devices including EPC4, EPC8, and EPC16 devices.
■ Serial configuration devices including EPCS1, EPCS4, EPCS16, EPCS64, and
EPCS128 devices.
In addition, you can perform SignalTap® II logic analysis.
The USB-Blaster download cable supports target systems using 5.0-V TTL, 3.3-V
LVTTL/LVCMOS, and single-ended I/O standards from 1.5 V to 3.3 V.
Power Requirements
The USB-Blaster download cable requires the following power sources:
■ 5.0 V from the USB cable
■ Between 1.5 V and 5.0 V from the target circuit board
海盗 最后编辑于 2010/1/8 9:38:40